Details, datasheet, quote on part number: M55310/18
PartM55310/18
CategoryTiming Circuits => Oscillators
Description.01Hz - 15MHz Crystal Oscillator
CompanyVectron International
DatasheetDownload M55310/18 datasheet
  

 

Features, Applications

PERFORMANCE SPECIFICATION SHEET OSCILLATOR, CRYSTAL CONTROLLED, TYPE 1 (CRYSTAL OSCILLATOR (XO)), 0.01 Hz THROUGH 15.0 MHz, HERMETIC SEAL, SQUARE WAVE, CMOS This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall consist of this specification and MIL-PRF-55310. Pin number Inches.002.018.100.150.20 mm Function B - (GND/CASE) OUTPUT B+ mm

NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Unless otherwise specified, tolerances are ±.005 (0.13 mm) for three place decimals and ±.02 (0.5 mm) for two place decimals. 4. All pins with NC function may be connected internally and are not to be used as external tie points or connections. FIGURE 1. Dimensions and configuration.

AMSC N/A of 5 DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.

MIL-PRF-55310/18D REQUIREMENTS: Interface and physical dimensions: See figure 1. Mounting: See figure 1. Terminals: See figure 1. Seal: Hermetic in accordance with MIL-PRF-55310, maximum leakage rate x 10 atm cc/s. Weight: 0.5 ounce, maximum. * Oscillator: Class 2 (see of MIL-PRF-55310). Calibration: Manufacturer calibrated. * Screening: In accordance with MIL-PRF-55310, product level S, as applicable. Temperature: Operating: See table I. Storage: to +125°C. Oscillator load: 10 kilohms ±5 percent shunted pF ±5 percent capacitor for CMOS compatible square. Output waveform: Symmetrical square wave. Output voltage: At designated CMOS load. Logic 1: See table I. Logic 0: See table I. Rise and fall times: See table I. Duty cycle: to 60 percent duty cycle. Supply voltage: See table I. Input current: At designated supply voltage (see table I). Output frequency: Frequency as designated at time of acquisition (see table I). Initial accuracy at reference temperature (up to 30 days after shipment): See table I. Initial frequency-temperature accuracy (one-half temperature cycle): Verification applicable. 1/ Frequency-temperature tolerance (one-half temperature cycle, referenced to frequency measured +23°C ±1°C, immediately prior to starting of the test): See table I. Measurements taken at ten equally spaced increments over the specified operating temperature range. 1/ For the purpose of transitioning this device to MIL-PRF-55310, `Frequency stability versus temperature' has been renamed `Frequency-temperature tolerance'. The verification requirements of `initial frequencytemperature accuracy (one-half temperature cycle)' shall apply except that frequency measurements shall be referenced to the frequency measured +23°C ±1°C (fref) instead of to the nominal frequency (fnom).

Dash number Output frequency range Supply voltage ±10% Maximum Input current at maximum supply voltage 1/ mA Output voltage Rise and fall times (max) Initial accuracy ppm +23°C ±1°C Frequency aging ppm/year after 30 days Frequency-temperature tolerance (ppm) +70°C C

1/ Maximum input current for no load condition. Actual configuration of CMOS loads must be added to determine power supply requirements.


 

Related products with the same datasheet
M55310/18-B01A
M55310/18-B01B
M55310/18-B01C
M55310/18-B02A
M55310/18-B02B
M55310/18-B02C
M55310/18-B11A
M55310/18-B11B
M55310/18-B11C
M55310/18-B12A
M55310/18-B12B
M55310/18-B12C
Some Part number from the same manufacture Vectron International
M55310/18-B01A .01Hz - 15MHz Crystal Oscillator
M55310/25 25MHz - 175MHz Crystal Oscillator

MQF45.0-1600/02 : Monolithic Crystal Filter (MCF) Pole No. = 4 ;; Loss /dB = 3.0 ;; Passband /dB = 3.0 ;; Passband /±kHz = 8.00 ;; Ripple /dB = 1.0 ;; Ripple /±kHz = 5.0 ;; Stopband /dB = 30 ;; Stopband /±kHz = 25.00 ;; Stopband /dB = 90 ;; Stopband /±kHz = 910.0 ;; Impedance R/ohm = 700 ;; Impedance C/pf = 2.00 ;; Remar

TC-200-DFF-416A : Frequency Range = 311.04MHz - 777.6MHz ;; Output Logic = Pecl ;; Package = 30.48 X 25.4 X 6.35 ;; Features = Complementary Pecl Output

TM-055-CFF-A : Timing Modules Frequency Range = 1.544 MHZ - 777.6 MHZ ;; Output = TTL / Pecl ;; Package (mm) = 50.8 X 50.8 X 14.86 ;; Features = DDS Based

VPE1-B1D : Programmable 14 X 9.8 X 4.7 MM Tall 4 Pads

C2410 : Temperature Compensated Crystal Oscillators - TCXO Vectron’s VTC4 Temperature Compensated Crystal Oscillator (TCXO) is a quartz stabilized, clipped sine wave output, temperature compensated oscillator, operating off either 2.8, 3.0, 3.3 or 5.0 volt supply.

VS-720-LPC-GAB-693.4830 : Voltage Controlled SAW Oscillator

VTC2J02A-10M000 : Voltage Controlled Temperature Compensated Crystal Oscillator

FX-104-CFC-D1H7 : Frequency Translator

FX-104-DFF-A316 : Frequency Translator

Same catergory

ASTX-03ASVTX-03Series : Crystal Oscillators. 18.3 X 11.7 X 4.7 MM Hcmos/ttl or Clipped Sine, 5Vdc 2MHz to 25MHz Revised 1/2003.

BTB1250DO-B : Crystal Oscillator SMD 12.500000mhz. Surface Mount Crystal Oscillators Seiko Epson Frequency range to 125.00MHz World's best selling SMD oscillator stocked in depth Output Enable/Disable now standard Excellent and price Output frequency range Power source voltage Temperature range Max. supply voltage Operating voltage Storage temp. Operating temp. Soldering condition Frequency stability.

CY2287PVC-1 : Frequency Timing Generators For PC And Server Motherboards. 100-MHz Spread Spectrum Clock Synthesizer/Driver with USB, Hublink, and SDRAM Support Mixed 2.5V and 3.3V Operation Multiple output clocks at different frequencies Three CPU clocks to 100 MHz Nine 3.3V SDRAM clocks at 100 MHz Eight synchronous PCI clocks at 33 MHz Two synchronous APIC clocks at 16.67 MHz or 33 MHz Two 3V66 clocks at 66 MHz Two USB clocks.

DQXO-3-SMOSC : Crystal Oscillators. .001 HZ to 10 KHZ Surface Mount Low Power Crystal Oscillator.

DS1073Z-10A : Timekeeping, Timers, and Counters. DS1073Z-10A 97MHz EconOscillator™.

FXO-61FH : Miniature Clock Crystal Oscillator. ¡Ultra-thin,thickness (5×3.2×1.2mm). ¡It is a compact and thin ceramic package with a matalized lead for surface mounting that is able to be automatically loaded. ¡Reflow soldering is possible. ¡CMOS, TTL IC direct drive is possible. Depending upon the frequency band, there is also a crystal oscillator with a CMOS-IC with a tri-state function built.

ICS9211-02 : Clock Circuits. Direct RAMbus(tm) Clock Generator. The is a High-speed clock generator providing 400 MHz differential clock source for direct RambusTM memory system. It includes DDLL (Distributed Delay locked loop) and phase detection mechanism to synchronize the direct RambusTM channel clock to an external system clock. ICS 9211-02 provides a solution for a broad range of Direct Rambus memory applications.

K1536BLC : Package = 9 X 11 MM J-lead ;; Frequency = 2.000 to 80.000 MHZ ;; Output Logic = CMOS ;; Supply Voltage = 3.3 Volt.

MC-146 : Quartz Devices. Thin SMD Low/medium-frequency.

MC100E310FN : 2:8 Differential Fanout Buffer , Package: Plcc, Pins=28. The is a low voltage, low skew 2:8 differential ECL fanout buffer designed with clock distribution in mind. The device fully differential clock paths to minimize both device and system skew. The E310 offers two selectable clock inputs to allow for redundant or test clocks to be incorporated into the system clock trees. The lowest tpd delay time results.

PI6C410M : 400MHz Clock Generator For Mobile PC. Clock Generator for Intel PCI-Express Mobile Chipset 14.318 MHz Crystal Input Selectable of and 400MHz CPU Output Frequencies SMBus: Power Management Control Spread Spectrum support (-0.5% down spread) Packages (Pb-free & Green available): -56-Pin TSSOP is a high-speed, low-noise clock generator designed to work with Intel Mobile PCI-Express Chipset.

PR : Crystal Oscillators. Technology = SMT ;; Package = 3.5 X 6.0 X 1.0 MM ;; Frequency = 12.000 to 100.000 MHZ.

RO2112C : SAW Resonators. Frequency = 433.420 ;; = Resonator. Ideal for European 433.420 MHz Transmitters Very Low Series Resistance Quartz Stability The is a true one-port, surface-acoustic-wave (SAW) resonator in a surface-mount, ceramic case. It provides reliable, fundamental-mode, quartz frequency stabilization of fixed-frequency transmitters operating at 433.420 MHz. This SAW is designed specifically for remote-control.

SD-A2990 : XO PECL Oscillators. Surface Mount 6 Pad 5x7mm Frequency Range (Mhz) : 125.0 - 312.5 Output/input : Fast Edge Differential, 3.3V.

VCO190-2200T : High Performance Signal Source. Model: VCO190-2200T Rev: A Date: 4/21/2003 Customer: VARI-L COMPANY Operating Temperature Range: ° C) Parameter Frequency Range Tuning Voltage: 2100 MHz 2300 MHz Tuning Sensitivity Output Power Output Phase Noise: 10 kHz 100 kHz Power Supply Current Harmonic Suppression: 2nd Harmonic 3rd Harmonic Spurious (Non-Harmonic) Frequency Pushing 4.75-5.25 V Frequency.

VCO190-2600T : High Performance Signal Source. Model: VCO190-2600T Rev: E Date: 4/21/2003 Customer: VARI-L COMPANY Operating Temperature Range: ° C) Parameter Frequency Range Tuning Voltage: 2500 MHz 2700 MHz Tuning Sensitivity Output Power Output Phase Noise: 10 kHz 100 kHz Power Supply Current Harmonic Suppression: 2nd Harmonic 3rd Harmonic Spurious (Non-Harmonic) Frequency Pushing 4.75-5.25 V Frequency.

RFX250 : • Pb Free • 7.5 x 5 x 1.4mm • 2.5V • LVE-PECL XO • Complementary Output.

 
0-C     D-L     M-R     S-Z