Details, datasheet, quote on part number: M55310/18-B42A
CategoryTiming Circuits => Oscillators
Description.01Hz - 15MHz Crystal Oscillator
CompanyVectron International
DatasheetDownload M55310/18-B42A datasheet
Find where to buy


Features, Applications

PERFORMANCE SPECIFICATION SHEET OSCILLATOR, CRYSTAL CONTROLLED, TYPE 1 (CRYSTAL OSCILLATOR (XO)), 0.01 Hz THROUGH 15.0 MHz, HERMETIC SEAL, SQUARE WAVE, CMOS This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall consist of this specification and MIL-PRF-55310. Pin number Inches. mm Function B - (GND/CASE) OUTPUT B+ mm

NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Unless otherwise specified, tolerances are .005 (0.13 mm) for three place decimals and .02 (0.5 mm) for two place decimals. 4. All pins with NC function may be connected internally and are not to be used as external tie points or connections. FIGURE 1. Dimensions and configuration.

AMSC N/A of 5 DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.

MIL-PRF-55310/18D REQUIREMENTS: Interface and physical dimensions: See figure 1. Mounting: See figure 1. Terminals: See figure 1. Seal: Hermetic in accordance with MIL-PRF-55310, maximum leakage rate x 10 atm cc/s. Weight: 0.5 ounce, maximum. * Oscillator: Class 2 (see of MIL-PRF-55310). Calibration: Manufacturer calibrated. * Screening: In accordance with MIL-PRF-55310, product level S, as applicable. Temperature: Operating: See table I. Storage: to +125C. Oscillator load: 10 kilohms 5 percent shunted pF 5 percent capacitor for CMOS compatible square. Output waveform: Symmetrical square wave. Output voltage: At designated CMOS load. Logic 1: See table I. Logic 0: See table I. Rise and fall times: See table I. Duty cycle: to 60 percent duty cycle. Supply voltage: See table I. Input current: At designated supply voltage (see table I). Output frequency: Frequency as designated at time of acquisition (see table I). Initial accuracy at reference temperature (up to 30 days after shipment): See table I. Initial frequency-temperature accuracy (one-half temperature cycle): Verification applicable. 1/ Frequency-temperature tolerance (one-half temperature cycle, referenced to frequency measured +23C 1C, immediately prior to starting of the test): See table I. Measurements taken at ten equally spaced increments over the specified operating temperature range. 1/ For the purpose of transitioning this device to MIL-PRF-55310, `Frequency stability versus temperature' has been renamed `Frequency-temperature tolerance'. The verification requirements of `initial frequencytemperature accuracy (one-half temperature cycle)' shall apply except that frequency measurements shall be referenced to the frequency measured +23C 1C (fref) instead of to the nominal frequency (fnom).

Dash number Output frequency range Supply voltage 10% Maximum Input current at maximum supply voltage 1/ mA Output voltage Rise and fall times (max) Initial accuracy ppm +23C 1C Frequency aging ppm/year after 30 days Frequency-temperature tolerance (ppm) +70C C

1/ Maximum input current for no load condition. Actual configuration of CMOS loads must be added to determine power supply requirements.


Related products with the same datasheet
Some Part number from the same manufacture Vectron International
M55310/18-B42B .01Hz - 15MHz Crystal Oscillator
M55310/25 25MHz - 175MHz Crystal Oscillator

VPE1-E1D : Programmable 14 X 9.8 X 4.7 MM Tall 4 Pads

VTA2-2B0 :

VTC2J13C-10M000 : Voltage Controlled Temperature Compensated Crystal Oscillator

C2260A1-0021 : TCXO EFC Standard Low Profile Small Size 100 % RoHS Compliant

VVC2-F1E-35.328 : Voltage Controlled Crystal Oscillator

VCB1-F3B-25M00 : 3.3, 5.0 volt CMOS Oscillator

VVC2-C2E-51.840 : Voltage Controlled Crystal Oscillator

VTC4-A21A-12M800 : Voltage Controlled Temperature Compensated Crystal Oscillator

FX-104-DFC-A3F7 : Frequency Translator

0-C     D-L     M-R     S-Z