Details, datasheet, quote on part number: M55310/16-S41B
CategoryTiming Circuits => Oscillators
Description16kHz - 60MHz Crystal Oscillator
CompanyVectron International
DatasheetDownload M55310/16-S41B datasheet


Features, Applications

PERFORMANCE SPECIFICATION SHEET OSCILLATOR, CRYSTAL CONTROLLED, TYPE 1 (CRYSTAL OSCILLATOR (XO)), 0.1 Hz THROUGH 80 MHz, HERMETIC SEAL, SQUARE WAVE, TTL This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall consist of this specification and MIL-PRF-55310. Pin number Function B - (GND/CASE) OUTPUT NC B+

NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Unless otherwise specified, tolerances are .005 (0.13 mm) for three place decimals and .02 (0.5 mm) for two place decimals. 4. All pins with NC function may be connected internally and are not to be used as external tie points or connections. FIGURE 1. Dimensions and configuration.

AMSC N/A of 4 DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.

MIL-PRF-55310/16H REQUIREMENTS: Interface and physical dimensions: See figure 1. Mounting: See figure 1. Terminals: See figure 1. Seal: Hermetic in accordance with MIL-PRF-55310, maximum leakage rate x 10-8 atm cc/s. Weight: 0.5 ounce, maximum. * Oscillator: Class 2 or any class 1 or class 3 oscillator meeting all class 2 requirements and verification tests specified herein and in MIL-PRF-55310. Calibration: Manufacturer calibrated. Screening: In accordance with MIL-PRF-55310, product level S, as applicable. Temperature: Operating: See table I. Storage: + 125C. Oscillator load: Standard TTL loads (see table I). Output waveform: Symmetrical square wave. Supply voltage: dc 10 percent. Input current: At designated supply voltage (see table I). Output frequency: Frequency as designated at time of acquisition (see table I). Output voltage: At designated TTL load (see table I). Logic 2.4 V dc, minimum. Logic 0.5 V dc, maximum. Rise and fall times: See table I. Duty cycle: See table I. Initial accuracy at reference temperature (up to 30 days after shipment): See table I. Initial frequency-temperature accuracy (one-half temperature cycle): Verification applicable. 1/ Frequency-temperature tolerance (one-half temperature cycle, referenced to frequency measured +23C 1C, immediately prior to starting of the test): See table I. Measurements taken at ten equally spaced increments over the specified operating temperature range. 1/ For the purpose of transitioning this device to MIL-PRF-55310, `Frequency stability versus temperature' has been renamed `Frequency-temperature tolerance'. The verification requirements of `initial frequency-temperature accuracy (one-half temperature cycle)' shall apply except that frequency measurements shall be referenced to the frequency measured +23C 1C (fref) instead of to the nominal frequency (fnom). 2

Maximum input current for no load condition. Actual configuration of TTL loads must be added to determine power supply requirements. A TTL unit load is defined as: 1.6 mA sink, 0.04 mA source, and 2pF capacitance.

Frequency-voltage tolerance: 2 ppm maximum for a 10 percent change in supply voltage. Measurements taken at reference temperature and operating temperature range end points. Frequency aging: Measurements shall be taken 0.2C at intervals of not more than every 72 hours for 30 days minimum (see table I). 5 ppm per year, maximum 0.7 ppm per 30 days. 1.5 ppm per 90 days Terminal strength: Method of MIL-STD-202, test condition C. Applied force: 2 pounds each terminal for 10 seconds. Bends: Five at 45 degrees each. Frequency-environmental tolerance: Not applicable. Vibration, sinusoidal: In accordance with MIL-PRF-55310 and method of MIL-STD-202. Nonoperating: Test condition D. Operating: Not required. 10 ppm per year, maximum 1.5 ppm per 30 days 3 ppm per 90 days


Related products with the same datasheet
Some Part number from the same manufacture Vectron International
M55310/16-S41C 16kHz - 60MHz Crystal Oscillator
M55310/18 .01Hz - 15MHz Crystal Oscillator
M55310/25 25MHz - 175MHz Crystal Oscillator

TDR7HYE : Frequency Range = 0.5MHz - 100MHz ;; Output Logic = CMOS/TTL, Siave ;; Package = R&s Series ;; Features = Stability to ± 0.05 Ppm, ± 1 PPM For Temp And 10 Years

VCA2-B3H : 0.8" X 0.5" X 0.2" 14 Pin Gull Lead SM

MQF21.4-1000-09 : Monolithic Crystal Filter

VTC4-C34E-12M800 : Voltage Controlled Temperature Compensated Crystal Oscillator

SO-720-LPC-GDA : SAW Based Clock Oscillator

VVC2-BHD-10.000 : Voltage Controlled Crystal Oscillator

FX-104-CFF-D2T6 : Frequency Translator

OC-160AAF-107CF-10 : Oven Controlled Crystal Oscillators

VDMHCD-44.736 : Voltage Controlled Crystal Oscillator

0-C     D-L     M-R     S-Z