Details, datasheet, quote on part number: SN54ALS243AFK
CategoryLogic => Bus Transceivers
DescriptionQuadruple Bus Transceivers With 3-state Outputs
CompanyTexas Instruments, Inc.
DatasheetDownload SN54ALS243AFK datasheet
Find where to buy


Features, Applications

Two-Way Asynchronous Communication Between Data Buses pnp Inputs Reduce dc Loading Package Options Include Plastic Small-Outline (D) Packages, Ceramic Chip Carriers (FK), and Standard Plastic (N) and Ceramic (J) 300-mil DIPs


These quadruple bus transceivers are designed for asynchronous two-way communication between data buses. The control-function implementation allows for maximum flexibility in timing. These devices allow data transmission from the A bus to the B bus or from the B bus to the A bus depending upon the logic levels at the output-enable (OEBA and OEAB) inputs. The output-enable inputs can be used to disable the device so that the buses are effectively isolated. The dual-enable configuration gives the quadruple bus transceivers the capability to store data by simultaneously enabling OEBA and OEAB. Each output reinforces its input in this transceiver configuration. When both control inputs are enabled and all other data sources to the two sets of bus lines are at high impedance, both sets of bus lines (eight in all) retain their states. The 4-bit codes appearing on the two sets of buses are identical.

The SN54ALS243A is characterized for operation over the full military temperature range to 125°C. The SN74ALS243A is characterized for operation from to 70°C.

PRODUCTION DATA information is current as of publication date. Products conform to specifications per the terms of Texas Instruments standard warranty. Production processing does not necessarily include testing of all parameters.

This symbol is in accordance with ANSI/IEEE Std 91-1984 and IEC Publication 617-12. Pin numbers shown are for the D, J, and N packages.

absolute maximum ratings over operating free-air temperature range (unless otherwise noted)

Supply voltage, VCC. 7 V Input voltage, VI: All inputs. 7 V I/O ports. 5.5 V Operating free-air temperature range, TA: to 70°C Storage temperature range. to 150°C

Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

SN54ALS243A MIN VCC VIH VIL IOH IOL TA Supply voltage High-level input voltage Low-level input voltage High-level output current Low-level output current Operating free-air temperature NOM 5 MAX 5.5 SN74ALS243A MIN NOM 5 MAX 5.5 UNIT mA °C

electrical characteristics over recommended operating free-air temperature range (unless otherwise noted)

VOL II IIH IIL IO§ ICC Control inputs or B ports Control inputs or B ports Control inputs or B ports

All typical values are at VCC = 25°C. For I/O ports, the parameters IIH and IIL include the off-state output current. § The output conditions have been chosen to produce a current that closely approximates one half of the true short-circuit output current, IOS.

¶ For conditions shown as MIN or MAX, use the appropriate value specified under recommended operating conditions.


Some Part number from the same manufacture Texas Instruments, Inc.
SN54ALS243AJ ti SN54ALS243A, Quadruple Bus Transceivers With 3-State Outputs
SN54ALS244AJ ti SN54ALS244A, Octal Buffer/drivers With 3-State Outputs
SN54ALS244C Octal Buffers And Line Drivers With 3-state Outputs
SN54ALS244CJ ti SN54ALS244C, Octal Buffers And Line Drivers With 3-State Outputs
SN54ALS244CN Octal Buffers And Line Drivers With 3-state Outputs
SN54ALS245AFK Octal Bus Transceivers With 3-state Outputs
SN54ALS245AJ ti SN54ALS245A, Octal Bus Transceivers With 3-State Outputs
SN54ALS251FK 1-of-8 Data Selectors/multiplexers With 3-state Outputs
SN54ALS251J ti SN54ALS251, 1-Of-8 Data Selectors/multiplexers With 3-State Outputs
SN54ALS253FK Dual 1-of-4 Data Selectors/multiplexers With 3-state Outputs
SN54ALS253J ti SN54ALS253, Dual 1-Of-4 Data Selectors/multiplexers With 3-State Outputs
SN54ALS257A Quadruple 2-line to 1-line Data Selectors/multiplexers With 3-state Outputs
SN54ALS257AJ ti SN54ALS257A, Quad 2-Line to 1-Line Data Selectors/multiplexers With 3-State
SN54ALS257J ti SN54ALS257, Quad 2-Line to 1-Line Data Selectors/multiplexers With 3-State Outputs
SN54ALS258A Quadruple 2-line to 1-line Data Selectors/multiplexers With 3-state Outputs

85507012A : D-Type (3-State) Flip-Flops ti SN54HCT374, Octal D-type Edge-triggered Flip-flops With 3-State Outputs

BQ26500PW : Gas Gauges ti BQ26500, Complete Battery Fuel Gauge For One And Two Cell Li-ion Applications

SN74ABT241ADBR : Non-Inverting Buffers and Drivers ti SN74ABT241A, Octal Buffers/drivers With 3-State Outputs

SN74CBT3245APWR : Standard Bus Switches ti SN74CBT3245A, Octal Fet Bus Switch

SN74S74N3 : D-Type Flip-Flops ti SN74S74, Dual D-type Positive-edge-triggered Flip-flops With Preset And Clear

PCM3060 : The PCM3060 is a low-cost, high-performance, single-chip, 24-bit stereo audio codec with single-ended analog inputs and differential analog outputs. The stereo 24-bit ADC employs a 64-times delta-sigma modulator. It supports 16-96 kHz sampling rates and a 16/24-bit digital audio output word on th

SN54LS607 : Synchronous Up/down Counters WITH Output Registers AND Multiplexed 3-state Outputs

SN74CB3Q3345_05 : 10-bit FET BUS Switch 2.5v/3.3v LOW Voltage BUS Switch 5-V Tolerant Level Shifter

CD4009UBPWRG4 : Inverting Buffers and Drivers ti CD4009UB, CMOS Hex Inverting Buffer/converter

TLC2272AQDRG4 : ti TLC2272A, Advanced LinCMOS(TM) Rail-to-rail Dual Operational Amplifier

UC3525ADWTRG4 : Voltage Mode ti UC3525A, Regulating Pulse Width Modulators

PGA308AQDGSRQ1 : Sensor Interface AC Sgl Supply,Auto Zero Sensor Amp Texas Instruments PGA308 Single-Supply Auto-Zero Sensor Amplifier is a programmable analog sensor signal conditioner. The analog signal path amplifies the sensor signal and provides digital calibration for offset and gain. Calibration is done via the 1W pin. This is a digital One-Wire, UART-compa

Same catergory

100363D : Low Power Dual 8-input Multiplexer. The is a dual 8-input multiplexer. The Data Select (Sn) inputs determine which bit (An and Bn) will be presented at the outputs (Za and Zb respectively). The same bit (0­7) will be selected for both the Za and Z b output. All inputs have 50 k pulldown resistors. 2000V ESD protection Pin/function compatible with 100163 Voltage compensated operating range.

74F114 : Bipolar->F Family. 74F114; Dual J-k Negative Edge-triggered Flip-flop With Common Clock And Reset.

74F2645PCQR : Octal Bus Transceiver With 25 Series Resistors in The Output.

74LCXZ16244 : CMOS/BiCMOS->LVT/ALVT/LCX/LPT Family->Low Voltage. Low Voltage 16-Bit Buffer/line Driver With 5V Tolerant Inputs And Outputs.

74VCX32373 : Low Voltage 32-Bit Transparent Latch With 3.6V Tolerant Inputs And Outputs.

CD40194BMS : CMOS/BiCMOS->4000 Family. Radiation Hardened CMOS 4-Bit Bidirectional Universal Shift Register.

DM74LS85 : Bipolar->AS Family. 4-bit Magnitude Comparators. These 4-bit magnitude comparators perform comparison of straight binary or BCD codes Three fully-decoded decisions about two 4-bit words (A B) are made and are externally available at three outputs These devices are fully expandable to any number of bits without external gates Words of greater length may be compared by connecting comparators in cascade.

IDT54FCT16841ET : Fast CMOS 20-bit Transparent Latches. Common : ­ 0.5 MICRON CMOS Technology ­ High-speed, low-power CMOS replacement for ABT functions ­ Typical tSK(o) (Output Skew) 250ps ­ Low input and output leakage 1µ A (max.) ­ ESD > 2000V per MIL-STD-883, Method > 200V using machine model 0) ­ Packages include 25 mil pitch SSOP, 19.6 mil pitch TSSOP, 15.7 mil pitch TVSOP and 25 mil pitch Cerpack.

MC100E404FNR2 : 5V Ecl Quad Differential AND/NAND, Package: Plcc, Pins=28. The a 4-bit differential AND/NAND device. The differential operation of the device makes it ideal for pulse shaping applications where duty cycle skew is critical. Special design techniques were incorporated to minimize the skew between the upper and lower level gate inputs. Because a negative 2-input NAND function is equivalent 2-input OR function,.

MM74C150 : Multiplexers->CMOS/BiCMOS->4000 Family. 16-line to 1-line Multiplexer.

NTE746 : Integrated Circuit. TV Video if Amplifier.. : The is a monolithic integrated circuit an 8­Lead DIP type package with wide­range AGC for replacement of 1st and 2nd IF stages in solid­state color and black and white TV sets. It will directly drive 3rd IF stage. : D Center Frequency: 45MHz D Bandwidth: 6MHz D Power Gain: 50dB Min D AGC Range: 60dB Min D Low Reverse­Transfer Admittance: 1µmho Typ Y21 Constant.

QS32XV245 : 3.3V High-speed Double Width Bus Switch. QUICKSWITCH® PRODUCTS 3.3V HIGH SPEED DOUBLEWIDTH BUS SWITCH 5 bidirectional switches connect inputs to outputs Pin compatibility with QS3245 250ps propagation delay Undershoot clamp diodes on all switch and control inputs LVTTL-compatible control inputs Available in 40-pin QVSOP package to 2.5V Voltage translation to 1.8V Voltage translation PCI bus isolation.

SN74LS292 : 30-bit Programmable Counter. PRODUCTION DATA information is current as of publication date. Products conform to s per the terms of Texas Instruments standard warranty. Production processing does not necessarily include testing of all parameters. .

TC74HCT86 : CMOS/BiCMOS->HC/HCT Family. Quad Exclusive OR GATE.

A32200DX-CQG208E : FPGA, 2414 CLBS, 20000 GATES, CQFP208. s: System Gates: 20000 ; Logic Cells / Logic Blocks: 2414 ; Package Type: QFP, Other, HEAT SINK, CAVITY-UP, CERAMIC, QFP-208 ; Logic Family: CMOS ; Pins: 208 ; Propagation Delay: 3.8 ns ; Supply Voltage: 5V.

0-C     D-L     M-R     S-Z