Details, datasheet, quote on part number: M48T513Y-70PL1
PartM48T513Y-70PL1
CategoryIC Timing Devices => IC Clocks => 6948138
Title0 TIMER(S), REAL TIME CLOCK, PDIP36
Description
CompanyST Microelectronics, Inc.
DatasheetDownload M48T513Y-70PL1 datasheet
Specifications 
Device TypeReal Time Clock
Package TypeDIP, PLASTIC, MODULE, DIP-36
Supply Voltage3 to 3.6 volts
Frequency0.0320 MHz
Operating Temperature0.0 to 70 C (32 to 158 F)

 

Features, Applications

INTEGRATED ULTRA LOW POWER SRAM, REAL TIME CLOCK, POWER-FAIL CONTROL CIRCUIT, BATTERY, and CRYSTAL YEAR 2000 COMPLIANT BCD CODED CENTURY, YEAR, MONTH, DAY, DATE, HOURS, MINUTES, and SECONDS BATTERY LOW WARNING FLAG AUTOMATIC POWER-FAIL CHIP DESELECT and WRITE PROTECTION TWO WRITE PROTECT VOLTAGES: (VPFD = Power-fail Deselect Voltage) M48T513Y: 4.2V VPFD M48T513V: 2.7V VPFD 3.0V

CONVENTIONAL SRAM OPERATION; UNLIMITED WRITE CYCLES SOFTWARE CONTROLLED CLOCK CALIBRATION for HIGH ACCURACY APPLICATIONS 10 YEARS of DATA RETENTION and CLOCK OPERATION in the ABSENCE of POWER SELF CONTAINED BATTERY and CRYSTAL in DIP PACKAGE MICROPROCESSOR POWER-ON RESET (Valid even during battery back-up mode) PROGRAMMABLE ALARM OUTPUT ACTIVE in BATTERY BACK-UP MODE SURFACE MOUNT CHIP SET PACKAGING INCLUDES a 44-PIN SOIC and a 32-LEAD TSOP (SNAPHAT TOP TO BE ORDERED SEPARATELY) SOIC PACKAGE PROVIDES DIRECT CONNECTION for a SNAPHAT TOP WHICH CONTAINS the BATTERY and CRYSTAL SNAPHATŪ HOUSING (BATTERY/CRYSTAL) IS REPLACEABLE

G W WDI RST RSTIN IRQ/FT VCC VSS Address Inputs Data Inputs / Outputs Chip Enable Input Output Enable Input Write Enable Input Watchdog input Reset Output (open drain) Reset Input Interrupt / Frequency Test Output (open drain) Supply Voltage Ground

Symbol TA TSTG V IO VCC IO PD Parameter Ambient Operating Temperature Storage Temperature (VCC Off, Oscillator Off) Input or Output Voltages M48T513Y Supply Voltage M48T513V Output Current Power Dissipation mA W Value ­0.3 to VCC to 7.0 Unit °C V

Note: 1. Stresses greater than those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational section of this specification is not implied. Exposure to the absolute maximum rating conditions for extended periods of time may affect reliability. 2. Soldering temperature not to exceed 260°C for 10 seconds (total thermal budget not to exceed 150°C for longer than 30 seconds).

CAUTION: Negative undershoots below ­0.3V are not allowed on any pin while in the Battery Back-up mode.

DESCRIPTION The M48T513Y/V TIMEKEEPER RAM x 8 non-volatile static RAM and real time clock, with programmable alarms and a watchdog timer. The special DIP package provides a fully integrated battery back-up memory and real time clock solution. The M48T513Y/V directly replaces industry standard x 8 SRAM. It also provides the non-volatility of Flash without any requirement for special write timing or limitations on the number of writes that can be performed.

For surface mount environments ST provides a Chip Set solution consisting a 44 pin 330mil SOIC TIMEKEEPER Supervisor (M48T201V/Y) and a 32 pin TSOP Type x 20mm) LPSRAM (M68Z512/W) packages. The 44 pin 330mil SOIC provides sockets with gold plated contacts at both ends for direct connection to a separate SNAPHAT housing containing the battery.

LITHIUM CELL VOLTAGE SENSE AND SWITCHING CIRCUITRY VPFD

The unique design allows the SNAPHAT battery package to be mounted on top of the SOIC package after the completion of the surface mount process. Insertion of the SNAPHAT housing after reflow prevents potential battery damage due to the high temperatures required for device surfacemounting. The SNAPHAT housing is keyed to prevent reverse insertion. The SNAPHAT battery package is shipped separately in plastic anti-static tubes or in Tape & Reel form. The part number is "M4Txx-BR12SH1". Figure 3 illustrates the static memory array and the quartz controlled clock oscillator. The clock locations contain the century, year, month, date, day, hour, minute, and second in 24 hour BCD format. Corrections for 28, 29 (leap year), 30, and 31 day months are made automatically. The nine clock bytes (7FFFFh-7FFF9h and 7FFF1h) are not the actual clock counters, they are memory locations consisting of BiPORTTM read/write memory cells within the static RAM array. The M48T513Y/V includes a clock control circuit which updates the clock bytes with current information once per second. The information can be accessed by the user in the same manner as any

other location in the static memory array. Byte 7FFF8h is the clock control register. This byte controls user access to the clock information and also stores the clock calibration setting. Byte 7FFF7h contains the watchdog timer setting. The watchdog timer can generate either a reset or an interrupt, depending on the state of the Watchdog Steering bit (WDS). Bytes 7FFF6h-7FFF2h include bits that, when programmed, provide for clock alarm functionality. Alarms are activated when the register content matches the month, date, hours, minutes, and seconds of the clock registers. Byte 7FFF1h contains century information. Byte 7FFF0h contains additional flag information pertaining to the watchdog timer, the alarm condition and the battery status. The M48T513Y/V also has its own Power-Fail Detect circuit. This control circuitry constantly monitors the supply voltage for an out of tolerance condition. When VCC is out of tolerance, the circuit write protects the TIMEKEEPER register data and external SRAM, providing data security in the midst of unpredictable system operation. As VCC falls, the control circuitry automatically switches to the battery, maintaining data and clock operation until valid power is restored.


 

Related products with the same datasheet
M48T513V-85CS1
M48T513V-85PL1
M48T513V-85PM1
M48T513Y-70CS1
M48T513Y-70PM1
M48T513Y-85CS1
M48T513Y-85PL1
Some Part number from the same manufacture ST Microelectronics, Inc.
M48T513Y-70PM1 Specifications: Device Type: Real Time Clock ; Package Type: DIP, PLASTIC, MODULE, DIP-36 ; Supply Voltage: 3 to 3.6 volts ; Frequency: 0.0320 MHz ; Operating Temperature: 0.0 to 70 C (32 to 158 F)
M48T559YMH1E Specifications: Device Type: Real Time Clock ; Package Type: Surface Mount, 0.330 INCH, LEAD FREE, PLASTIC, SOH-28 ; Supply Voltage: 4.5 to 5.5 volts ; Operating Temperature: 0.0 to 70 C (32 to 158 F) ; Features
M48T58 Specifications: Device Type: Real Time Clock ; Bus Interface: CMOS ; Package Type: Surface Mount, 0.330 INCH, SNAPHAT, SOH-28
M48T59
M48T8-100PC1 Specifications: Device Type: Real Time Clock ; Package Type: DIP, 0.600 INCH, PLASTIC, DIP-28 ; Supply Voltage: 4.75 to 5.5 volts ; Frequency: 0.0320 MHz ; Operating Temperature: 0.0 to 70 C (32 to 158 F)
M48Z08Y-10MH1 Specifications: Memory Category: NVRAM, NVSRAM, SRAM Chip ; Density: 66 kbits ; Number of Words: 8 k ; Bits per Word: 8 bits ; Package Type: SOIC, SNAPHAT, PLASTIC, SOIC-28 ; Pins: 28 ; Supply Voltage:
M48Z256-120PL1 Specifications: Memory Category: NVRAM, NVSRAM, SRAM Chip ; Density: 2097 kbits ; Number of Words: 256 k ; Bits per Word: 8 bits ; Pins: 32 ; Logic Family: CMOS ; Supply Voltage: 5V ; Access Time: 120 ns ; Operating
M48Z2M1V-70PL1 Specifications: Memory Category: NVRAM, NVSRAM, SRAM Chip ; Density: 16777 kbits ; Number of Words: 2000 k ; Bits per Word: 8 bits ; Package Type: DIP, PLASTIC, MODULE, DIP-36 ; Pins: 36 ; Logic Family:
M48Z35AY-70MH1E Specifications: Memory Category: NVRAM, NVSRAM, SRAM Chip ; Density: 262 kbits ; Number of Words: 32 k ; Bits per Word: 8 bits ; Package Type: SOIC, LEAD FREE, PLASTIC, SOIC-28 ; Pins: 28 ; Supply Voltage:
M48Z35V-100MH1
M48Z512A-70PM6 Specifications: Memory Category: NVRAM, NVSRAM, SRAM Chip ; Density: 4194 kbits ; Number of Words: 512 k ; Bits per Word: 8 bits ; Package Type: DIP, PLASTIC, MODULE, DIP-32 ; Pins: 32 ; Logic Family:
M54HC148D1 Specifications: Number of Bits: 8 ; Supply Voltage: 4.5 ; Package Type: DIP, CERAMIC, DIP-16 ; Logic Family: CMOS ; Number of Pins: 16 ; Propagation Delay: 225 ns ; Operating Temperature: -55 to 125 C (-67
M54HC238D1 Specifications: Function: Decoder ; Supply Voltage: 4.5 ; Package Type: DIP, CERAMIC, DIP-16 ; Logic Family: CMOS ; Number of Pins: 16 ; Propagation Delay: 225 ns ; Operating Temperature: -55 to 125 C (-67
M54HC280D Specifications: Number of Bits: 9 ; Supply Voltage: 4.5 ; Package Type: DIP, CERAMIC, DIP-14 ; Logic Family: CMOS ; Number of Pins: 14 ; Propagation Delay: 290 ns ; Operating Temperature: -55 to 125 C (-67
M54HC298B1N Specifications: Flip-Flop Type: D ; Triggering: Negative-edge Triggered ; Output Characteristics: TRUE ; Propagation Delay: 210 ns ; Operating Temperature: -55 to 125 C (-67 to 257 F) ; Package Type: DIP,
M54HC367F1 Specifications: Technology: CMOS ; Device Type: Line / Bus Driver ; Supply Voltage: 5V ; Operating Temperature: -55 to 125 C (-67 to 257 F) ; Package Type: DIP, FRIT SEALED, CERAMIC, DIP-16 ; Pins: 16
M54HC390D Specifications: Counter Type: BCD/Decade Counter ; Counter Category: Asynchronous ; Counter Direction: UP ; Supply Voltage: 4.5 ; Package Type: DIP, CERAMIC, DIP-16 ; Logic Family: CMOS, HC/UH ; Number
M54HC393D1 Specifications: Counter Type: BINARY COUNTER ; Counter Category: Asynchronous ; Counter Direction: UP ; Supply Voltage: 4.5 ; Package Type: DIP, CERAMIC, DIP-14 ; Logic Family: CMOS, HC/UH ; Number of Pins:
M54HC4050BF1 Specifications: Gate Type: NON-INVERT ; Supply Voltage: 5V ; Logic Family: CMOS ; Inputs: 1 ; Propagation Delay: 26 ns ; Operating Temperature: -55 to 125 C (-67 to 257 F) ; Pin Count: 16 ; IC Package
M54HC4511F1R Specifications: Function: Decoder ; Output Lines: 7-Segment ; Supply Voltage: 5V ; Package Type: DIP, CERAMIC, DIP-16 ; Logic Family: CMOS ; Number of Pins: 16 ; Propagation Delay: 77 ns ; Operating Temperature:

M29W800T150M5R : 8 Mbit 1mb x8 or 512kb X16, Boot Block Low Voltage Single Supply Flash Memory

VND1NV04-1 : OmniFET II: Fully Autoprotected Power MOSFET

STR712FR2 : STR71x: 144/64-pin ARM7TDMI MCU with up to 256KB FLASH, 64KB RAM and EMI

PSD913F5-12JIT : Flash In-system Programmable ISP Peripherals For 8-bit MCUs

M68AW128ML70ND6E : 2 Mbit (128k x16) 3.0V Asynchronous SRAM

STM8AH6198TCY : MICROCONTROLLER, PQFP32 Specifications: Life Cycle Stage: ACTIVE ; Package Type: LFQP, Other, 7 X 7 MM, LQFP-32 ; Pin Count: 32

STM8L151K3U6 : 8-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PQFP48 Specifications: Life Cycle Stage: ACTIVE ; Clock Speed: 16 MHz ; ROM Type: Flash ; Supply Voltage: 1.8 to 3.6 volts ; I/O Ports: 41 ; Package Type: LFQP, Other, 7 X 7 MM, ROHS COMPLIANT, LQFP-48 ; Operating Range: Auto ; Pin Count: 48 ; Operating Temperature: -40 to 125 C (-40 to 257 F) ; Features:

5962-86053043A : HC/UH SERIES, 4-BIT MAGNITUDE COMPARATOR, TRUE OUTPUT, CDFP16 Specifications: Number of Bits: 4 ; Supply Voltage: 4.5 ; Package Type: CERAMIC, DFP-16 ; Logic Family: CMOS ; Number of Pins: 16 ; Propagation Delay: 295 ns ; Operating Temperature: -55 to 125 C (-67 to 257 F)

 
0-C     D-L     M-R     S-Z