Details, datasheet, quote on part number: NTE5180A
PartNTE5180A
CategoryDiscrete => Diodes & Rectifiers => Voltage Regulators
DescriptionZener Diode, 10 Watt, +-5% Tolerance. Nominal Zener Voltage VZ = 3.9V. Zener Test Current Izt = 640mA.
CompanyNTE Electronics, Inc.
DatasheetDownload NTE5180A datasheet
Quote
Find where to buy
 
  

 

Features, Applications

Features: D Zener Voltage D DO4 Stud Mount Package Absolute Maximum Ratings: Forward Voltage (IF = 2A), VF. 1.5V DC Power Dissipation, PD. 10W Derate Above 50C. 80mW/C Operating Junction Temperature Range, Topr. to +175C Storage Temperature Range, Tstg. to +175C Electrical Characteristics: (TC = +30C, unless otherwise specified)

Electrical Characteristics (Cont'd): (TC = +30C, unless otherwise specified)

Nominal Zener Voltage Vz @ Izt (Note 2) Volts 8.7 Zener Test Current (Izt) mA 290 Maximum Dynamic Impedance (Note 3) Zzt @ Izt Ohms 1.7 Zzk @ 1mA (Izk) Ohms 250 Maximum DC Zener Current* (Izm) (Note mA 1000 Typical Temperature Coefficient vz %/C.049 Maximum Leakage Current VR A Volts 37 6.6

Nominal Zener Voltage Vz @ Izt (Note 2) Volts Zener Test Current (Izt) mA Maximum Dynamic Impedance (Note 3) Zzt @ Izt Ohms Zzk @ 1mA (Izk) Ohms Maximum DC Zener Current* (Izm) (Note 4) mA Typical Temperature Coefficient vz %/C Maximum Leakage Current VR A Volts

* Stud Temperature = +75C Note 1. The NTE type 10W Zener Diodes listed have Anode (Standard Polarity) connected to stud. Add suffix letter "K" to the device number for Cathode (Reverse Polarity) connected to stud (i. e. NTE5174AK). Note 2. The electrical characteristics are measured after allowing the device to stabilize for 90 seconds with +30C base temperature. Note 3. The zener impedance (Zzt) is derived from the 60Hz AC voltage, which results when an AC current having an RMS value equal 10% of the DC zener current (IZT or IZK) is superimposed on IZT or IZK. When making zener impedance measurements at the IZK test point, it may be necessary to insert a 60Hz band pass filter between the diode and voltmeter to avoid errors resulting from low level noise signals. Note 4. These values of IZM may be exceeded in the case of individual diodes. The values shown are calculated for the worst case which is a unit of 5% tolerance at the high voltage and of its tolerance range. Allowance has also been made for the rise in zener voltage above VZT, which results from zener impedance and the increase in junction temperature as power dissipation approaches 10 watts.


 

Related products with the same datasheet
NTE5175A
NTE5176A
NTE5177A
NTE5178A
NTE5179A
NTE5181A
NTE5182A
NTE5183A
NTE5184A
NTE5185A
NTE5186A
Some Part number from the same manufacture NTE Electronics, Inc.
NTE5181A Zener Diode, 10 Watt, +-5% Tolerance. Nominal Zener Voltage VZ = 3.9V. Zener Test Current Izt = 640mA.
NTE519 Silicon Rectifier Diode. Ultra Fast Switch. Repetitive Peak Reverse Voltage 100V. Average Forward Current 150mA.
NTE5190A Zener Diode, 10 Watt, +-5% Tolerance. Nominal Zener Voltage VZ = 3.9V. Zener Test Current Izt = 640mA.
NTE52 NTE52, Silicon NPN Transistor High Voltage, High Speed Switch
NTE5200A Zener Diode, 10 Watt, +-5% Tolerance. Nominal Zener Voltage VZ = 3.9V. Zener Test Current Izt = 640mA.
NTE5240A 50 Watt Zener Diode, +-5% Tolerance. Nominal Zener Voltage VZ = 3.9V. Zener Test Current Izt = 3200mA.
NTE524V13 Metal Oxide Varistors ( Mov )
NTE524V48
NTE525 Silicon Diode. High Voltage, Fast Recovery Switch.
NTE5250A 50 Watt Zener Diode, +-5% Tolerance. Nominal Zener Voltage VZ = 3.9V. Zener Test Current Izt = 3200mA.

NTE1410 : NTE1410, Integrated Circuit Chroma Video Signal Processor

NTE180 : Silicon Power PNP Transistor. High Power Audio Amplifier.

NTE2954 : NTE2954, MOSFET N Channel, Enhancement Mode

NTE5240AK : 50 Watt Zener Diode, +-5% Tolerance. Nominal Zener Voltage VZ = 3.9V. Zener Test Current Izt = 3200mA.

NTE5825 : Silicon Power Rectifier. Stud Mount, Fast Recovery, 12 Amp. Peak Repetitive Reverse Voltage 200V. Non-repetitive Peak Reverse Voltage 250V.

NTE5835 : Stud Mount Standart Recovery. Silicon Rectifier, 3 Amp. Peak Repetitive Reverse Voltage, DC Blocking Voltage 50V.

NTE5944 : Silicon Power Rectifier Diode. Cathode to Case. Max Repetitive Peak Reverse Voltage 50V. Average Forward Current 15A.

SCTA.B.C.D.H223K35 : Surface Mount Tantalum

NEVH1.0M350 : Aluminum Electrolytic 160V to 450V

NLE-SR22M506.3X5F : Miniature Aluminum Electrolytic Capacitors

NLE-L100M506.3X11F : Miniature Aluminum Electrolytic Capacitors

 
0-C     D-L     M-R     S-Z