Details, datasheet, quote on part number: NJM2068
PartNJM2068
CategoryAnalog & Mixed-Signal Processing => Amplifiers => Operational Amplifiers
DescriptionLow-noise Dual Operational Amplifier
CompanyNJR Corporation
DatasheetDownload NJM2068 datasheet
Quote
Find where to buy
 
  
Related products with the same datasheet
NJM2068D
NJM2068L
NJM2068M
NJM2068V
Some Part number from the same manufacture NJR Corporation
NJM2068D Low-noise Dual Operational Amplifier
NJM2070 Low Voltage Power Amplifier
NJM2072 Signal Level Sensor System
NJM2073 Dual Low Voltage Power Amplifier
NJM2076
NJM2078 Voltage Detector
NJM2082 Dual J-FET Input Operational Amplifier
NJM2085 Pre Amplifier And Dolby B Type Noise Reduction System
NJM2096 Low Voltage Dual Power Amplifier
NJM2097 Hex op Amp
NJM2100 Dual Operational Amplifier
NJM2102 System Reset ic
NJM2103
NJM2105 Telephone Speech Network ic
NJM2106 Active Bass Expander
NJM2107 Single Operational Amplifier
NJM2110 Monoral Mic Amp.for Video Camera
NJM2112 Quad Operational Amplifier
NJM2113 Low Voltage Audio Power Amplifier
NJM2114 High-performance Low-noise Dual Operational Amplifier
NJM2115 Dual Operational Amplifier

NJG1101F-C3 : Wide Band Agc Amplifier GAAS Mmic

NJL30H/V000A : Infrared Remote Control Receiver

NJM13403 : Single Supply Quad Operational Amplifier

NJM2136V : Ultra Wide Band,high Slew Rate Single Operational Amplifier

NJM2380AM : Adjustable High Precision Shunt Regulator

NJM2893 : 3 Output Low Dropout Voltage Regulator

NJU28001 : MPEG/JPEG/H.261 Mpeg-2 Image Processor

NJU6450A : LCD Controller Drivers 16Com × 61Seg Output Bit Map LCD Driver

NJW1325 : Multi Input Wide Band Video Interface With I2C Control NJW1325 is a multi input wide band video interface IC with I2C control. Also the NJW1325 includes 6-input 3 channel video switch for SD, 4-input 3 channel video switch for HD,11 channel 75-ohm driver for SD, 3-channel buffer for SD and 12 chann

Same catergory

5962-9312901MPA : High-speed, Low-noise Video op Amp. High Speed 120 MHz Bandwidth, Gain V/ s Slew Rate 90 ns Settling Time to 0.1% Ideal for Video Applications 0.02% Differential Gain 0.04 Differential Phase Low Noise 1.7 nV/Hz Input Voltage Noise 1.5 pA/Hz Input Current Noise Excellent DC Precision 1 mV max Input Offset Voltage (Over Temp) 0.3 V/C Input Offset Drift Flexible Operation Specified for 15 V Operation.

74FR900 : 9-Bit 3-Port Latchable Datapath Multiplexer. The is a data bus multiplexer routing any of three 9-bit ports to any other one of the three ports. Readback of data latched from any port onto itself is also possible. The 74FR900 maintains separate control of all latch-enable, output enable and select inputs for maximum flexibility. PINV allows inversion of the data from the or B8 path. This is useful.

ADM1232 : Power. Microprocessor Supervisory Circuit. Superior Upgrade for MAX1232 and Dallas DS1232 Low Power Consumption (500 A max) Adjustable Precision Voltage Monitor with +4.5 V and +4.75 V Options Adjustable STROBE Monitor with 150 ms, or 1.2 sec Options No External Components Fast (20 ns) Strobe Pulsewidth APPLICATIONS Microprocessor Systems Portable Equipment Computers Controllers Intelligent.

AN1358 : Dual Operational Amplifiers. The AN1358S (AN6562S) are dual operational amplifiers with two phase compensation circuits built-in, have a wide range of operaing supply voltage, and can operate on a single power supply. They have electrical characteristics equivalent to those of the conventional operational amplifiers, and are lowpowered and suitable for application to various circuits.

CMV1036YR : Micropower Pro Operational Amplifier With Shutdown.

HT82V733 : HT82V733 240mA Audio Power Amp. High signal-to-noise ratio High slew rate Low distortion Large output voltage swing Excellent power supply ripple rejection Low power consumption Short-circuit elimination Wide temperature operating range No switch ON/OFF clicks Low standby current Power off control Direct drive speaker 8-pin DIP/SOP package is an integrated class AB mono speaker driver.

KA2181 : Remote Control Preamplifier. This Data Sheet is subject to change without notice. Page KA2181 ) This Data Sheet is subject to change without notice. Page KA2181 ) This Data Sheet is subject to change without notice. Page KA2181 ) .

LH4002A : Wideband Video Buffer. GENERAL 5V The LH4002 family is a high speed voltage follower designed to drive video signals from 300MHz. At voltage supplies of 5V, the LH4002 family will provide to 80mA into 50 at slew rates of 2000 V/s. The LH4002 family is intended to fulfill a wide range of high speed applications including video distribution, impedance transformation, and load.

LTC1062 : LTC1062, 5th Order, 20kHz, Butterworth, DC Accurate, Low Pass Filter. Lowpass Filter with No DC Error Low Passband Noise Operates to 20kHz Operates On a Single 5V Supply 8V 5th Order Filter Maximally Flat Response Internal or External Clock Cascadable for Faster Rolloff Buffer Available The a 5th order all pole maximally flat lowpass filter with no DC error. Its unusual architecture puts the filter outside the DC path.

MAX4036 : Low Ibias, +1.4V/800nA, Rail-to-rail op Amps With +1.2V Buffered Reference operational Amplifiers Operate From a Single +1.4V to +3.6V (without Reference) or +1.8V to +3.6V (with Reference) Supply And Consume Only 800nA of Supply Current Per Amplifier, And 1.1A For The Optional Reference.key Applications Ultra-Low 800nA Per Amplifier Supply Current.

OP77AJ : Next Generation Op07, Ultralow Offset Voltage Operational Amplifier.

TC75W54FK : Dual Operational Amplifier.

TCM3105DJE : FSK Modem.

TDA8575 : Ground Noise ISOlation Amplifier. Preliminary File under Integrated Circuits, IC01 1996 Jul 29 High common mode rejection up to high frequencies Reduced dependency of common mode rejection on source resistance Low distortion Low noise AC and DC short-circuit safe Few external components ESD protected on all pins. GENERAL The is a two channel amplifier with differential input and single-ended.

TL074ACD : ti TL074A, Low-noise JFET-input Operational Amplifier. D Low Input Bias and Offset Currents D Output Short-Circuit Protection D Low Total Harmonic Distortion = 18 nV/Hz Typ = 1 kHz High Input Impedance. JFET Input Stage Internal Frequency Compensation Latch-Up-Free Operation High Slew Rate. 13 V/s Typ Common-Mode Input Voltage Range Includes VCC+ The JFET-input operational amplifiers in the TL07_ series.

TLC27M2MFK : Lincmose Precision Dual Operational Amplifiers. Trimmed Offset Voltage: 500 V Max at 25C, VDD 5 V Input Offset Voltage Drift. Typically 0.1 V/Month, Including the First 30 Days Wide Range of Supply Voltages Over Specified Temperature Ranges: 16 V Single-Supply Operation Common-Mode Input Voltage Range Extends Below the Negative Rail (C-Suffix, I-Suffix Types) Low Noise. Typically 32 nV/Hz = 1 kHz Low Power.

TLV2241CD : ti TLV2241, Single Micropower, 2.5-V, Rrio, Single Supply Amplifier. Micropower Operation. 1 A/Channel Rail-to-Rail Input/Output Gain Bandwidth Product. 5.5 kHz Supply Voltage Range. 12 V Specified Temperature Range to 70C. Commercial Grade to 125C. Industrial Grade Ultrasmall Packaging 8-Pin MSOP (TLV2242) Universal OpAmp EVM The TLV224x family of single-supply operational amplifiers offers very low supply current.

MAX4983E : High-Speed USB 2.0 Switches With 15kV ESD The MAX4983E/MAX4984E are high ESD-protected analog switches that combine the low on-capacitance and low on-resistance necessary for high-performance switching applications. COM1 and COM2 are protected against 15kV ESD without latchup or damage. The devices are ideal for USB 2.0 high-speed applications at 480Mbps.

MAX5394 : Single, 256-Tap Volatile, SPI, Low-Voltage Linear Taper Digital Potentiometer The MAX5394 single, 256-tap volatile, low-voltage linear taper digital potentiometer offers three end-to-end resistance values of 10k?, 50k?, and 100k?. Potentiometer terminals are independent of supply for voltages up to 5.25V with single-supply operation from 1.7V to 5.5V.

 
0-C     D-L     M-R     S-Z