|Description||4 X 4 Multiport Register|
|Company||Motorola Semiconductor Products|
|Datasheet||Download MC14580BCL datasheet
The by 4 multiport register useful in small scratch pad memories, arithmetic operations when coupled with an adder, and other data storage applications. It allows independent reading of any two words (or the same word at both outputs) while writing into any one of four words. Address changing and data entry occur on the rising edge of the clock. When the write enable input is low, the contents of any word may be accessed but not altered. No Restrictions on Clock Input Rise or Fall Times 3State Outputs Single Phase Clocking Supply Voltage Range = 3.0 Vdc to 18 Vdc Capable of Driving Two Lowpower TTL Loads or one Lowpower Schottky TTL Load Over the Rated Temperature Range Pin Compatible with CD40108 MAXIMUM RATINGS* (Voltages Referenced to VSS)
Symbol VDD Vin, Vout Iin, Iout PD Tstg TL Parameter DC Supply Voltage Input or Output Voltage (DC or Transient) Input or Output Current (DC or Transient), per Pin Power Dissipation, per Package Storage Temperature Lead Temperature (8Second Soldering) L SUFFIX CERAMIC CASE 623Q2A Q3A WRITE 0 WRITE 1 READ 1B READ 0B VSS VDD D2 D3 CLOCK WE READ 1A READ 0A
* Maximum Ratings are those values beyond which damage to the device may occur. Temperature Derating: Plastic "P and D/DW" Packages: 7.0 mW/_C From To 125_C Ceramic "L" Packages: 12 mW/_C From To 125_C©MOTOROLA Motorola, Inc. 1995 CMOS LOGIC DATA
#Data labelled "Typ" is not to be used for design purposes but is intended as an indication of the IC's potential performance. The formulas given are for the typical characteristics only 25_C. To calculate total supply current at loads other than 50 pF: IT(CL) = IT(50 pF) + (CL 50) Vfk where: in µA (per package), CL in pF, V = (VDD VSS) in volts, f in kHz is input frequency, and = 0.004.
This device contains protection circuitry to guard against damage due to high static voltages or electric fields. However, precautions must be taken to avoid applications of any voltage higher than maximum rated voltages to this high-impedance circuit. For proper operation, Vin and Vout should be constrained to the range VSS (Vin or Vout) VDD. Unused inputs must always be tied to an appropriate logic voltage level (e.g., either VSS or VDD). Unused outputs must be left open.
When loading repetitive highs, the output may glitch low momentarily after the rising edge of Clock. However, data integrity remains unaffected and data is valid after the propagation delays listed in the Switching Characteristics Table.
IDS Sink Current EXTERNAL POWER SUPPLY Position of S1 VGS = VDS = 2 VDD Vout Source Current 1 VDD Vout VDDFigure 1. Output Drive Current Test Circuit
|Related products with the same datasheet|
|Some Part number from the same manufacture Motorola Semiconductor Products|
|MC14580BCP 4 X 4 Multiport Register|
|MC14581BCL 4-bit Arithmetic Logic Unit|
|MC14582BCL Look-ahead Carry Block|
|MC14583BCL Dual Schmitt Trigger|
|MC14584BCL Hex Schmitt Trigger|
|MC14585BCL 4-bit Magnitude Comparator|
|MC1458D Dual Operational Amplifier|
|MC14597BCL 8-bit Bus-compatible Latches|
MC54F827J : 10-bit Buffers/line Drivers ( With 3-state Outputs )
MC68HC05F8 : CISC->68XX Family Hcmos Microcontroller
MJ10020 : NPN Silicon Power Darlington Transistor
MRF6S24140HR3_08 : RF Power Field Effect Transistors
MC68HC11E1CB3 : 16-bit Modular Microcontroller
MC68HC11P2CFN3 : 16-bit Modular Microcontroller
MC68HC711A0CFN4 : Technical Summary 8-bit Microcontroller
74LS133 : 13-input NAND GATE
MPC5565MVZ112R2 : Microcontroller
MCF5235EC : Integrated Microprocessor Hardware Specification
74ABT861 : 74ABT861; 10-bit Bus Transceiver (3-State);; Package: SOT137 (SO24), SOT222-1 (DIP24), SOT340-1 (SSOP24), SOT355-1 (TSSOP24).
CY74FCT16823TSSOP : 18-bit Registers. Data sheet acquired from Cypress Semiconductor Corporation. Data sheet modified to remove devices not offered. CY74FCT162823T : Balanced 24 mA output drivers Reduced system switching noise Typical VOLP (ground bounce) <0.6V at VCC = 5V, TA= 25°C FCT-E speed at 4.4 ns Power-off disable outputs permits live insertion Edge-rate control circuitry for significantly.
DS8614 : 130/225 MHZ Low Power Dual Modulus Prescalers. The DS8615 series products are low power dual modulus prescalers which divide 32 33 and 40 41 respectively The modulus control (MC) input selects division by N when at a high TTL level and division a 1 when at a low TTL level The clock inputs are buffered providing 40 100 mVrms input sensitivity The two outputs provide the user the option to wire either.
DS8627 : 130 MHZ Low Power Prescaler. The DS8627 and DS8628 are low power fixed ratio prescalers which divide by 24 and 20 respectively The inputs can be driven either single or double-ended and they are buffered providing 40 100 mVrms input sensitivity The output provided is open-collector and is capable of interfacing with TTL and CMOS The device can be used in phase-locked loop applications.
HCC4517B : Dual 64-stage Static Shift Register. CLOCK FREQUENCY 12MHz (TYP.) AT VDD = 10V SCHMITT TRIGGER CLOCK INPUTS ALLOW OPERATION WITH VERY SLOW CLOCK RISE AND FALL TIMES THREE-STATE OUTPUTS QUIESCENT CURRENT SPECIFIED AT 20V FOR HCC DEVICE STANDARDIZED, SYMMETRICAL OUTPUT CHARACTERISTICS 5V, 10V, AND 15V PARAMETRIC RATINGS INPUT CURREN AT 18V AND 25°C FOR HCC DEVICE 100% TESTED FOR QUIESCENT.
HD74ALVCHR162269A : 12-bit to 24-bit Registered Bus Exchanger With 3-state Outputs. The to 24-bit registered bus exchanger, which is intended for applications where two separate ports must be multiplexed onto, or de-multiplexed from, a single port. It is particularly suitable as an interface between synchronous DRAMs and high speed microprocessors. The HD74ALVCHR162269A is designed specifically for low voltage (from 3.3 V) VCC operation.
IDTQS32X383 : Quickswitch(r) Products High-speed CMOS 20-bit Bus Exchange Switch. QUICKSWITCH® PRODUCTS HIGH-SPEED CMOS 20-BIT BUS EXCHANGE SWITCH Enhanced N channel FET with no inherent diode to Vcc 5 bidirectional switches connect inputs to outputs Zero propagation delay Zero ground bounce Undershoot clamp diodes on all switch and control pins 20-bit Double-Width format Bus exchange allows nibble swap Zero ground bounce iin flow-through.
M74HC573 : HC/HCT->High Speed CMOS. Octal D-type Latch With 3-STATE Output (NON INVERTING).
MC10E241 : Bipolar->ECL 10 Family. 8-bit Scannable Register. The an 8-bit shiftable register. Unlike a standard universal shift register such as the E141, the E241 internal data feedback organized so that the SHIFT control overrides the HOLD/LOAD control. This enables the normal operations of HOLD and LOAD to be toggled with a single control line without the need for external gating. It also enables switching.
MC74LCX16240 : Low-voltage CMOS 16-Bit Buffer. The is a high performance, inverting 16bit buffer operating from 3.6 V supply. The device is nibble controlled. Each nibble has separate Output Enable inputs which can be tied together for full 16bit operation. High impedance TTL compatible inputs significantly reduce current loading to input drivers while TTL compatible outputs offer improved switching.
S-75V32ANC : . General . . Applications. Pin Assignment. Marking. Logic Diagram. Physical Dimensions. Ordering. Absolute Maximum Ratings. Recommended Operating Conditions DC Characteristics. AC Characteristics. Input Pin Equivalent Circuit. Frequently Asked Questions. The is a single 2-intput OR gate fabricated by utilizing advanced silicon-gate CMOS technology which.
SK100EL11W : 1:2 Differential Fanout Buffer. The is a differential 1:2 fanout buffer. This device is fully compatible with MC10/100EL11 and MC100LVEL11. With output transition time much faster than the E111, the EL11W is ideally suited for those applications which require ultimate AC performance. Under open input conditions, the pulldown resistors will force the Q0 and Q1 outputs low and Q0* and Q1* high.
SN54F30FK : 8-input Positive-nand Gates. Package Options Include Plastic Small-Outline Packages, Ceramic Chip Carriers, and Standard Plastic and Ceramic 300-mil DIPs These devices contain a single 8-input NAND gate. They perform the Boolean functions or in positive logic. The SN54F30 is characterized for operation over the full military temperature range to 125°C. The SN74F30 is characterized.
SN74AHC132 : CMOS/BiCMOS->HC/HCT Family. Quad Positive-nand Gates With Schmitt-trigger Inputs.
SN74BCT25244DW : Non-Inverting Buffers and Drivers. ti SN74BCT25244, Octal 25-Ohm Buffers/drivers With 3-State Outputs.
TC8521AM : Real Time Clock Q.
SN65C3221E : 3-V To 5.5-V Single Channel RS-232 1 Mbit/s Line Driver/Receiver The SN65C3221E and SN75C3221E consist of one line driver, one line receiver, and a dual charge-pump circuit with ±15-kV IEC ESD protection pin to pin (serial-port connection pins, including GND). These devices provide the electrical interface between an asynchronous communication controller.
A2F200M3D-FG484 : FPGA, 4608 CLBS, 200000 GATES, PBGA484. s: System Gates: 200000 ; Logic Cells / Logic Blocks: 4608 ; Package Type: Other, 1 MM PITCH, FBGA-484 ; Logic Family: CMOS ; Pins: 484 ; Operating Temperature: 0 to 85 C (32 to 185 F) ; Supply Voltage: 1.5V.
A3P125-1FG144YI : FPGA, 3072 CLBS, 125000 GATES, PBGA144. s: System Gates: 125000 ; Logic Cells / Logic Blocks: 3072 ; Package Type: Other, 13 X 13 MM, 1.45 MM HEIGHT, 1 MM PITCH, FPBGA-144 ; Logic Family: CMOS ; Pins: 144 ; Operating Temperature: -40 to 85 C (-40 to 185 F) ; Supply Voltage: 1.5V.
CD4541M96 : 4000/14000/40000 SERIES, SYN POSITIVE EDGE TRIGGERED 16-BIT UP BINARY COUNTER, PDSO14. s: Counter Type: BINARY COUNTER ; Counter Category: Synchronous ; Counter Direction: UP ; Supply Voltage: 5V ; Package Type: SOIC, PLASTIC, MS-012, SOIC-14 ; Logic Family: CMOS, 4000/14000/40000 ; Number of Pins: 14 ; Number of Stages (Bits): 16 bits ; Operating Temperature:.