|Category||Interface and Interconnect => SCSI => SCSI driver development|
|Title||SCSI driver development|
|Description||Pci to Ultra Scsi Host Adapter User's Guide V1.1 1/01|
|Company||LSI Logic Corporation|
|Datasheet||Download LSI20860 datasheet
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. 2. This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
Shielded cables for SCSI connection external to the cabinet are used in the compliance testing of this Product. LSI Logic is not responsible for any radio or television interference caused by unauthorized modification of this equipment or the substitution or attachment of connecting cables and equipment other than those specified by LSI Logic. The correction of interferences caused by such unauthorized modification, substitution, or attachment will be the responsibility of the user. The LSI Logic LSI20860 is tested to comply with FCC standards for home or office use.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
This is a Class B product based on the standard of the Voluntary Control Council for Interference from Information Technology Equipment (VCCI). If this is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual.LSI Logic Corporation North American Headquarters Milpitas, CA 408.433.8000
This document contains proprietary information of LSI Logic Corporation. The information contained herein is not to be used by or disclosed to third parties without the express written permission of an officer of LSI Logic Corporation. LSI Logic products are not intended for use in life-support appliances, devices, or systems. Use of any LSI Logic product in such applications without written consent of the appropriate LSI Logic officer is prohibited. Document DB15-000129-01, Second Edition (January 2001). This document describes the LSI Logic LSI20860 PCI to Ultra SCSI Host Adapter and will remain the official reference source for all revisions/releases of this product until rescinded by an update. To receive product literature, visit us at http://www.lsilogic.com. LSI Logic Corporation reserves the right to make changes to any products herein at any time without notice. LSI Logic does not assume any responsibility or liability arising out of the application or use of any product described herein, except as expressly agreed to in writing by LSI Logic; nor does the purchase or use of a product from LSI Logic convey a license under any patent rights, copyrights, trademark rights, or any other of the intellectual property rights of LSI Logic or third parties. Copyright 19992001 by LSI Logic Corporation. All rights reserved. TRADEMARK ACKNOWLEDGMENT The LSI Logic logo design and SDMS are registered trademarks or trademarks of LSI Logic Corporation. All other brand and product names may be trademarks of their respective companies.
|Some Part number from the same manufacture LSI Logic Corporation|
|LSI21002 Pci to Dual Channel Scsi Host Adapter User's Guide V1.1 11/00|
|LSI21003 Pci to Dual Channel Scsi Host Adapter User's Guide V1.0 10/00|
|LSI21040 Pci to Dual Channel Ultra 160 Scsi Host Adapter User's Guide V1.1 11/00|
|LSI22902 Host Adapter to Intel ISP1100 Internet Server Quick Installation Guide V1.1 11/00|
|LSI22910 Pci to Dual Channel Pci to Ultra2 Scsi Host Adapter User's Guide V1.1 12/00|
|LSI22915A Pci to Dual Channel Ultra160 Scsi Host Adapter User's Guide V1.2 4/01|
|LSI401Z Digital Signal Processor|
|LSI402ZX Detailedoverview of Features, Specifications, Functional Waveforms,signal Descriptions, Functional Descriptions, Instruction Setsummary And Block Diagram|
|LSI40909G-S Pci to Fibre Channel Host Adapter For Sun Solaris User's Guide Erratum-E1 V1.0 4/01|
|LSI53C040 Enclosure Services Processor Programming Guide V1.1 12/00|
|LSI53C1000 Pci to Ultra160 Scsi Controller Technical Manual V2.1 2/01|
|LSI53C1000R Pci to Ultra160 Scsi Controller Technical Manual V2.1 5/01|
|LSI53C1010-33 Pci to Dual Channel Ultra160 Scsi Multifunction Controller Technical Manual V3.2 2/01|
|LSI53C1010-66 Pci to Dual Channel Ultra160 Scsi Multifunction Controller Technical Manual V2.1 2/01|
|LSI53C1020 Pci-x to Ultra320 Scsi Controller Technical Manual V2.1 6/03|
8020 : Protocol Controllers MCC (tm) Manchester Code Converter
LQ80220 : 100base-tx/10base-t Ethernet Media Interface Adapter
QQ84C30A : 10 MBPS Controller (MAC) Manual 12/96
ZSP410 : DSP core with integrated debug and timer capabilities The ZSP410 is a synthesizable high-performance 16-bit fixed point digital signal processor (DSP) based upon the ZSP architecture. An enhanced version of the ZSP400 embedded DSP, the ZSP410 utilizes a 0-, 1- or 2-way set associative instruction c
LSISAS1064E : 4-Port PCI Express to 3Gb/s SAS Controller The LSISAS1064E is a four-port 3.0Gb/s Serial Attached SCSI (SAS) controller that is based on the Fusion-MPT™ (Message Passing Technology) architecture and provides an eight-lane PCI Express interface. The LSI Logic SAS integrated controller provides
70V657 : Multi-Ports. 32K X 36 3.3V Dual-port RAM, Interleaved I/o's. True Dual-Port memory cells which allow simultaneous access of the same memory location High-speed access Commercial: 10/12/15ns (max.) Industrial: 12/15ns (max.) Dual chip enables allow for depth expansion without external logic IDT70V657 easily expands data bus width to 72 bits or more using the Master/Slave select when cascading more than one device.
74FR245S : Octal Bidirectional Transceiver With Tri-state Outputs.
LB1987M : . Three-Phase Brushless Motor Driver for VCR Capstan Motors Three-phase full-wave current-linear drive Torque ripple correction circuit (fixed correction ratio) Current limiter circuit with control characteristics gain switching Oversaturation prevention circuits for both the upper and lower sides of the output stage (No external capacitors are required.).
LSIU40SE : SCSI driver development. Dual Channel Pci to Ultra Scsi Host Adapter User's Guide V2.2 8/02.
LTC1320 : LTC1320, +/-5V Appletalk Transceiver. Single Chip Provides Complete LocalTalk©/AppleTalk© Port Low Power: ICC = 1.2mA Typ Shutdown Pin Reduces ICC to 30µA Typ Drivers Maintain High Impedance in Three-State or with Power Off 30ns Driver Propagation Delay Typ 5ns Driver Skew Typ Thermal Shutdown Protection Drivers are Short-Circuit Protected The an RS422/RS562 line transceiver designed to operate.
LXT360 : Integrated T1/e1 Lh/sh Transceivers For Ds1/dsx-1/csu or Ntu/isdn Pri Applications.
MC1489AN : ti MC1489A, Quadruple Line Receiver. Input Resistance. 7 k Input Signal Range. 30 V Operate From Single 5-V Supply Built-In Input Hysteresis (Double Thresholds) Response Control that Provides: Input Threshold Shifting Input Noise Filtering Meet or Exceed the Requirements of TIA / EIA-232-F and ITU Recommendation V.28 Fully Interchangeable With MotorolaTM MC1489 and MC1489A The NS package.
MODELUSBAEC16 : Usb Active Extension Cable. USB Active Extension Cable is not a passive extension cable. is an active device. With Model USBAEC16 the USB signals going in and out of the extension cable are buffered to assure signal quality. Passive USB cables cannot be used for lengths over 5 meters. The a 16 foot long cable (approximately 5 meters). By putting five USBAEC16 cables in series.
PCF2103 : PCF2103 Family; LCD Controllers/drivers. Product File under Integrated Circuits, IC12 1998 May 11 CONTENTS APPLICATIONS GENERAL ORDERING INFORMATION BLOCK DIAGRAM PINNING FUNCTIONAL LCD bias voltage generator Oscillator External clock Power-on reset Power-down mode Registers Busy flag Address Counter (AC) Display Data RAM (DDRAM) Character Generator ROM (CGROM) Character Generator RAM (CGRAM).
SN65LBC175A : . Designed for TIA/EIA-485, TIA/EIA-422, and ISO 8482 Applications Signaling Rate1 Exceeding 50 Mbps Fail-Safe in Bus Short-Circuit, Open-Circuit, and Idle-Bus Conditions ESD Protection on Bus Inputs Exceeds 6 kV Common-Mode Bus Input Range 12 V Propagation Delay Times <16 ns Low Standby Power Consumption <20 µA Pin-Compatible Upgrade for DS96F175,.
SN65LVDS051 : High-speed Differential Line Receiver. Meets or Exceeds the Requirements of ANSI TIA/EIA-644-1995 Standard Signaling Rates to 400 Mbps Bus-Terminal ESD Exceeds 12 kV Operates From a Single 3.3-V Supply Low-Voltage Differential Signaling With Typical Output Voltages 350 mV and a 100- Load Propagation Delay Times Driver: 1.7 ns Typ Receiver: 3.7 ns Typ Power Dissipation at 200 MHz Driver:.
ST3384E : 15kv Esd-protected, 3 to 5.5v, Low Power, up to 250kbps, Rs-232 Transceiver.
UCN5895 : . BiMOS II 8-BIT SERIAL INPUT, LATCHED SOURCE DRIVERS The UCN5895A, UCN5895EP, and A5895SLW BiMOS II serialinput, latched source drivers are designed for applications emphasizing low output saturation voltages and currents -250 mA per output. These smart high-side octal, driver ICs merge an 8-bit CMOS shift register, associated CMOS latches, and CMOS.
W83194AR-WE : 200mhz Clock For Whitney Chipset. The is a Clock Synthesizer for Intel Whitney chipset. W83194AR-We provides all clocks required for high-speed RISC or CISC microprocessor and also provides 64 different frequencies of CPU, SDRAM, PCI, 3V66, IOAPIC clocks frequency setting. All clocks are externally selectable with smooth transitions. The W83194AR-We provides I C serial bus interface.
MAX3230E : ±15kV ESD-Protected +2.5V To +5.5V RS-232 Transceivers In UCSP And WLP The MAX3230E/AE and MAX3231E/AE are +2.5V to +5.5V powered EIA/TIA-232 and V.28/V.24 communications interfaces with low power requirements, high datarate capabilities, and enhanced electrostatic discharge (ESD) protection, in a chip-scale package (UCSP™) and WLP package. All transmitter.
UJA1076TW : High-speed CAN Core System Basis Chip The UJA1076 core System Basis Chip (SBC) replaces the basic discrete components commonly found in Electronic Control Units (ECU) with a high-speed Controller Area Network (CAN). The UJA1076 supports the networking applications used to control power and sensor peripherals by using a high-speed CAN as the main network.