Details, datasheet, quote on part number: MB84VD22082EA
PartMB84VD22082EA
CategoryMemory => Flash
Description32m ( X 8/x16 ) Flash Memory & 2m ( X 8/x16 ) Static RAM
CompanyFujitsu Microelectronics, Inc.
DatasheetDownload MB84VD22082EA datasheet
Quote
Find where to buy
 
  

 

Features, Applications

Stacked MCP (Multi-Chip Package) FLASH MEMORY & SRAM

Power supply voltage to 3.3V High performance 90 ns maximum access time (Flash) 85 ns maximum access time (SRAM) Operating Temperature to +85C Package 73-ball FBGA

Flash Memory Ordering Part No. VCCf, VCCs 3.0 V
Max. Address Access Time (ns) Max. CE Access Time (ns) Max. OE Access Time (ns)

Simultaneous Read/Write operations (dual bank) Multiple devices available with different bank sizes Host system can program or erase in one bank, then immediately and simultaneously read from the other bank Zero latency between read and write operations Read-while-erase Read-while-program Minimum 100,000 write/erase cycles Sector erase architecture Eight 4 K words and sixty three 32 K words. Any combination of sectors can be concurrently erased. Also supports full chip erase. Boot Code Sector Architecture MB84VD2208XEA: Top sector MB84VD2209XEA: Bottom sector Embedded EraseTM Algorithms Automatically pre-programs and erases the chip or any sector Embedded ProgramTM Algorithms Automatically writes and verifies data at specified address Data Polling and Toggle Bit feature for detection of program or erase cycle completion Ready-Busy output (RY/BY) Hardware method for detection of program or erase cycle completion Automatic sleep mode When addresses remain stable, automatically switch themselves to low power mode. Low VCCf write inhibit 2.5 V Hidden ROM (Hi-ROM) region 64K byte of Hi-ROM, accessible through a new "Hi-ROM Enable" command sequence Factory serialized and protected to provide a secure electronic serial number (ESN) WP/ACC input pin At VIL, allows protection of boot sectors, regardless of sector protection/unprotection status MB84VD2209XEA:SA0,SA1) At VIH, allows removal of boot sector protection At VACC, program time will reduse by 40%. Erase Suspend/Resume Suspends the erase operation to allow a read in another sector within the same device Please refer to "MBM29DL32XTE/BE" data sheet in detailed function

Power dissipation Operating 40 mA max. Standby 7 A max. Power down features using CE1s and CE2s Data retention supply voltage: V CE1s and CE2s Chip Select Byte data control: LBs to DQ15)

Embedded EraseTM and Embedded ProgramTM are trademarks of Advanced Micro Devices, Inc.




 

Related products with the same datasheet
MB84VD22082EA-90-PBS
Some Part number from the same manufacture Fujitsu Microelectronics, Inc.
MB84VD22082EA-90-PBS 32m ( X 8/x16 ) Flash Memory & 2m ( X 8/x16 ) Static RAM
MB84VD22083EA
MB84VD22084EA
MB84VD2208XEA-90
MB84VD2208XEA-90 CMOS 32m (x8/x16) Flash Memory & 2m (x8/x16) Static RAM
MB84VD22091EA 32m ( X 8/x16 ) Flash Memory & 2m ( X 8/x16 ) Static RAM
MB84VD22092EA-90-PBS
MB84VD22094EA
MB84VD2209XEA-90
MB84VD2209XEA-90 CMOS 32m (x8/x16) Flash Memory & 2m (x8/x16) Static RAM
MB84VD22181EC 32m ( X 8/x16 ) Flash Memory & 4m ( X 8/x16 ) Static RAM
MB84VD2218XA-10 CMOS 32m (x 8/x16) Flash Memory & 4m (x 8/x16) Static RAM
MB84VD2218xEB-85
MB84VD2218XEC 32m ( X 8/x16 ) Flash Memory & 4m ( X 8/x16 ) Static RAM
MB84VD2218XEC-90
MB84VD2218XEC-90 CMOS 32m (x8/x16) Flash Memory & 4m (x8/x16) Static RAM
MB84VD2218xEE-85
MB84VD2218XEE-90
MB84VD2218XEE-90 CMOS 32m (x8/x16) Flash Memory & 4m (x8/x16) Static RAM
MB84VD2218XEG 32m ( X 8/x16 ) Flash Memory & 4m ( X 8/x16 ) Static RAM
MB84VD2218XEG-90

2SK2870-01LS : High voltage N-channel MOSFET

FAR-C3SB-11000-K21-U : Piezoelectric Resonator

FAR-C4CL-33869-K12-R : Piezoelectric Resonator ( 4 to 16 MHZ )

FBR12WD04 :

MB84VD21082 : 16m ( X8/x16 ) Flash Memory & 2m ( X8/x16 ) Static RAM

MB90673PFV : CISC->MB 16-bit Proprietary Microcontroller CMOS F2mc-16l Mb90670/675 Series

MBM29DL322BE12PBT : Flash Memory CMOS 32M (4M X 8/2 X 16)bit Dual Operation

MB85RC128PNF-G-JNERE1 : SPECIALTY MEMORY CIRCUIT, PDSO8 Specifications: Density: 131 kbits ; Number of Words: 16 k ; Bits per Word: 8 bits ; Package Type: SOP, 3.90 X 5.05 MM, 1.75 MM HEIGHT, 1.27 MM PITCH, PLASTIC, SOP-8 ; Pins: 8 ; Logic Family: CMOS ; Supply Voltage: 3.3V ; Operating Temperature: -40 to 85 C (-40 to 185 F)

MB95F133NBWPFV : 8-BIT, FLASH, 16.25 MHz, MICROCONTROLLER, PDSO28 Specifications: Life Cycle Stage: ACTIVE ; Clock Speed: 32.5 MHz ; ROM Type: Flash ; Supply Voltage: 3.5 to 5.5 volts ; I/O Ports: 20 ; Package Type: SOP, Other, 8.60 X 17.75 MM, 2.80 MM HEIGHT, 1.27 MM PITCH, PLASTIC, SOP-28 ; Operating Range: Industrial ; Pin Count: 28 ; Operating Temperature: -40

Same catergory

93AA66-P : 1k/2k/4k 1.8v Microwire Serial EePROM. Single supply with programming operation down to 1.8V Low power CMOS technology 70 A typical active READ current 2 A typical standby current at 1.8V ORG pin selectable memory configuration x 16-bit organization x 16-bit organization x 16 bit organization (93AA66) Self-timed ERASE and WRITE cycles (including auto-erase) Automatic ERAL before WRAL Power.

AT49LV1024 : 1M. 1m (64k X 16) 3-volt Only Flash Memory. 3V Read 3.1V Programming Fast Read Access Time 55 ns Internal Program Control and Timer 8K Word Boot Block with Lockout Fast Erase Cycle Time 10 seconds Word-by-Word Programming 20 s/Word Typical Hardware Data Protection Data Polling for End of Program Detection Small 14 mm VSOP Package Typical 10,000 Write Cycles The AT49LV1024 and the AT49LV1025.

EDS2508APSA : 256m Bits Sdram. The a 256M bits SDRAM organized as 8,388,608 words 8 bits 4 banks. The a 256M bits SDRAM organized as 4194304 words 16 bits 4 banks. All inputs and outputs are referred to the rising edge of the clock input. It is packaged in standard 60-ball BGA. 3.3V power supply Clock frequency: 133MHz (max.) LVTTL interface Single pulsed /RAS 4 banks can operate.

HM5225405B-75 : 256m LVTTL Interface Sdram 133 Mhz/100 MHZ 4-mword 16-bit 4-bank/8-mword 8-bit 4-bank /16-mword 4-bit 4-bank Pc/133, Pc/100 Sdram.

IS61SP6464 : 64Kx64 Synchronous Pipelined Static RAM. Fast access time: 117, 100 MHz; ns (83 MHz); Internal self-timed write cycle Individual Byte Write Control and Global Write Clock controlled, registered address, data and control PentiumTM or linear burst sequence control using MODE input Five chip enables for simple depth expansion and address pipelining Common data inputs and data outputs Power-down.

IS62LV5128LL : 512Kx8 Low Power And Low VCC CMOS Static RAM. Access times 70, 85 ns CMOS low power operation: 135 mW (typical) operating 16.5 W (typical) standby Low data retention voltage: 2V (min.) Output Enable (OE) and Chip Enable (CE) inputs for ease in applications TTL compatible inputs and outputs Fully static operation: No clock or refresh required Single 2.7V (min) to 3.15V (max) VCC power supply Available.

K7N803249B : NtRAM(FT & PP). = K7N803249B 256Kx36 & 512Kx18-Bit Pipelined NtRAMTM™ ;; Organization = 256Kx32 ;; Operating Mode = Nt-pp ;; VDD(V) = 2.5 ;; Access Time-tCD(ns) = - ;; Speed-tcyc (MHz) = 250,200 ;; I/o Voltage(V) = 2.5 ;; Package = 100TQFP ;; Production Status = Mass Product ;; Comments = -.

KMMR18R8GAC1 : Normal RIMM. = KMMR18R8GAC1 4/6/8/12/16d RIMM(TM) Module With 128Mb Rdram ;; Density(MB) = 256 ;; Organization = 128Mx18 ;; Component Composition = 144M(2nd)x16 ;; Voltage(V) = 2.5 ;; Refresh = 16K/32m(1.9us) ;; Speed(MHz)/ TRAC(ns) = 300/53.3,356/45,400/45 ;; #of Pin = 184 ;; Production Status = Eol ;; Comments = Ds,ecc.

MH1V36CAM : FPM. Fast Page Mode 32m (1mx36) DRAM. Some of contents are subject to change without notice. The an 1M word by 36-bit dynamic RAM module and consists of 2 industry standard X 16 dynamic RAMs in TSOP and 1 industry standard X 4(4CAS) dynamic RAMs in TSOP. The ICs are mounted on both sides of one small ceracom PC board with flash gold plating and form a convenient 68-pin package. Type name.

N36S363WP1A : Synch, Pipeline, 36, 2.5, 3.3, 133 - 300, 2.3 - 4.0, 100-TQFP,. NanoAmp Solutions, Inc. 1982 Zanker Road, San Jose, CA 95112 ph: 408-573-8878, FAX: 408-573-8877 www.nanoamp.com High performance synchronous operation Cycle times to 300MHz Access times as fast as 2.3nS Single device supports power supply or 2.5V Separate I/O power supply or 2.5V User selectable pipeline and flow-thru operating modes for BGA devices.

WF1M32B : Flash MCP. Organization = 1Mx32 ;; Speed (ns) = 100-150 ;; Volt = 3.3 ;; Package = 68 CQFP ;; Temp = C,i,m ;;.

HYS72T64300HP-3.7-A : 240-Pin Registered DDR2 SDRAM Modules 512MB, 64Mx72, PC2-4200 4-4-4, 1 rank, available Q2/06.

IDT7132 : HIGH SPEED 2K X 8 DUAL PORT STATIC RAM The IDT7132/IDT7142 are high-speed 2K x 8 Dual-Port Static RAMs. The IDT7132 is designed to be used as a stand-alone 8-bit Dual-Port RAM or as a “MASTER? Dual-Port RAM together with the IDT7142 “SLAVE? Dual-Port in 16-bit-or-more word width systems. Using the IDT MASTER/ SLAVE Dual-Port RAM approach in 16-or-more-bit.

PCD8582-I/P : 256 X 8 I2C/2-WIRE SERIAL EEPROM, PDIP8. s: Density: 2 kbits ; Number of Words: 256 k ; Bits per Word: 8 bits ; Bus Type: Serial ; Production Status: Full Production ; Data Rate: 0 MHz ; Supply Voltage: 5V ; Package Type: 0.300 INCH, PLASTIC, DIP-8, DIP ; Pins: 8 ; Operating Range: Industrial ; Operating Temperature: -40 to 85 C (-40 to 185 F).

 
0-C     D-L     M-R     S-Z