Details, datasheet, quote on part number: PAC500AQR
CategoryCommunication => Network
DescriptionP/active ac Termination Network
CompanyCalifornia Micro Devices Corporation
DatasheetDownload PAC500AQR datasheet
Some Part number from the same manufacture California Micro Devices Corporation
PAC500AQT P/active ac Termination Network
PAC500FR4GQ High-performance Parallel Terminators, Package : QSOP-24
PAC500GQR P/active High Performance Gtl/ecl Local Termination Network
PAC500JR6GQ High-performance 1% Parallel Terminators, Package : QSOP-24
PAC500QR P/active Emi/rfi T Filter
PAC500R4GQ High Performance Bus Termination Network
PAC500R6GQ Emi/rtit-filter
PAC500R6GQR Emi/rfit-filter
PAC500RGQ P/active High Performance Gtl/ecl Local Termination Ntework
PAC500TFQR P/active Emi/rfitapped Filter
PAC510FRPIQ ISOlated Resistor Array / Series Terminators, Package : QSOP-24
PAC510FRPIQ24R P/active 1% Tolerance Precision ISOlated Series Termination Network
PAC560FR4GQ High-performance Parallel Terminators, Package : QSOP-24
PAC560FRPIQ24 P/active 1% Tolerance Precision ISOlated Series Termination Network

CM8870CQI : CMOS Integrated DTMF Receiver

CM8888-1 : DTMF Receiver/Transceiver CMOS Integrated DTMF Transceiver

PRC1284-07ST : Micropower Pro Operational Amplifier With Shutdown

PRN1101639R0J : ISOlated Resistor Termination Network

PRN110164700J : ISOlated Resistor Termination Network

CM1452-06CP : California Micro Devices’ CM1452 is a family of pi-style EMI filter arrays with ESD protection, which integrates four, six and eight filters (C-L-C) in CSP form factor with 0.40mm pitch. Each EMI filter channel of the CM1452 is implemented as a 3-pole L-C filter where the component values are 20pF-1

NCC5003DBGL : Bussed Resistor Network

XRN772-2005JBGL : Thin Film Resistor Series

XRN772-2005KBGLP : Thin Film Resistor Series

XRN740-1005KAW : Stable Extended Capability Chip Series

CM1240-04D4 : Dual-voltage ESD Protection Array for USB Port

Same catergory

ARA1400 : . Low cost integrated monolothic GaAs amplifier with step attenuator Attenuation Range: 0-56 dB, adjustable in 4dB increments via a 4 wire parallel control Meets DOCSIS distortion requirements at +60dBmV output signal level Low distortion and low noise Frequency range: 5-100MHz 5 Volt operation +85 0C temperature range options available MCNS/DOCSIS Compliant.

BU8315F : . The BU8315S and BU8315F are LED drivers with a flashing function. They can be connected in series to panel PCBs in equipment such as telephones, facsimile machines, and copying machines, and to microcomputers of main PCBs, and significantly reduce the amount of wiring required. FApplications Sets with operation panels, such as telephones, facsimile.

CY7C53120E2-10AI : Neuron Chip Network Processorthe CY7C531x0 Neuron Chip Implements a Node For Lonworks Distributed Intelligent Control Networks. It Incorporates, on a Single Chip, The Necessary Communication And Control Functions, Both in Hardware And Firmware, That Facilitate The Design of a Lonworks Node..

DW9241 : 78.81mhz Low Loss Saw Filter For Personal Communications. The filter is realised on ST-Quartz, using Unidirectional Transducer technology, which provides excellent insertion loss, and temperature stability. The unique design odviates the need for distinct Roof & Channel filters, usually required to achieve a low shape factor, with maximum bandwidth. The filters can be used in single or cascade format, and are available.

HT93214A : HT93214 Series 1-memory Tone/pulse Dialer. Operating Voltage: 2.0V~5.5V Low standby current Low memory retention current: 0.1mA (Typ.) Tone/Pulse switchable 32 (pulse)/31 (tone) digits for redialing Pause and ® T key for PBX 4´4 keyboard matrix 3.58MHz crystal or ceramic resonator Hand-free control Pause, ® T can be saved for redialing One-key redialing Keytone output Pause time: 2.2s Cascadable.

IMP16C552 : Dual Uart With Parallel Port. IBM PC ATTM and PS/2TM compatible Dual channel version of Ei16C550 with Centronics printer interface Independent control of transmit, receive, line status and data set interrupts on each channel Programmable serial interface characteristics for each channel: or 8 bit characters -Even, odd or no parity bit generation and dectection or 2 stop bit generation.

MAX2683EVKIT : MAX2683EVKIT, MAX2684EVKIT Evaluation Kits For The MAX2683/MAX2684. The MAX2683/MAX2684 evaluation kits (EV kits) simplify evaluation of the to 3.8GHz downconverter mixers. The EV kits are fully assembled and tested, allowing simple evaluation of all device functions. All signal ports utilize SMA connectors, providing a convenient interface to RF test equipment. The MAX2683/MAX2684 are downconversion mixers intended.

MF1105-1 : Filter For The if Circuit of GSM Hand Held. Item Center Fraquency (f0) Bandwidth (f0-3 dB) Insertion Loss at f0 Pass Band Ripple Group Delay Ripple Frequency range 246.0 MHz 246.0 MHz ± 110 kHz ± 110 kHz f0 ­21.6 MHz f0 ­10.8 MHz ­ 1.2 MHz ­ 0.7 MHz ­ 0.6 MHz This SAW filter for the IF filter circuit of GSM hand held 1. SMD package insures small size, lightweight. 2. Adjustment free. 3. Low insertion.

ML2037 : 500khz, Serial Input, Programmable Sine Wave Generator With Digital Gain Control.

MSM7712 : P802.11 Wireless Lan Mac. The MSM7712 is the first release in a series of wireless LAN baseband controllers, designated.XI (a suffix of the IEEE P802.11 protocol). The MSM7712 integrates the baseband physical layer and the lower MAC layers into a single IC that supports specific draft standards of the P802.11 . The architecture targets optimum integration with maximum user flexibility,.

MT91L61 : 3 V Multi-featured Phone Codec With Programmable U/a Law Companding. MT91L60/61 3 Volt Multi-Featured Codec (MFC) Advance Information Single 2.7-3.6 volt supply operation MT91L61 version a delayed framing pulse in SSI and ST-BUS modes to facilitate cascaded devices Programmable µ-Law/A-Law Codec and Filters Programmable ITU-T (G.711)/sign-magnitude coding Programmable transmit, receive and side-tone gains Fully differential.

PEB20324 : Multichannel Network Interface Controller With 128 Channels Extended. Multichannel Network Interface Controller for HDLC + Extensions MUNICH128X PEB 20324 Version 2.2 PEB 20324, PEF 20324 Revision History: Previous Version: Page (in previous (in current Version) Chapter 6 Chapter 5 Current Version: 04.99 Product Overview 12/97 DS3 Subjects (major changes since last revision) For questions on technology, delivery and prices.

PGR20312 : Apd Receiver Module up to 3 Gb/s. Hermetic, 14 pin butterfly package with multisourced footprint FC/PC, or ST connector InGaAs APD with low noise GaAs MMIC preamplifier AC-coupled, differential data output Operates between 1250 nm and 1620 nm 2.0 GHz minimum bandwidth -34 dBm typical sensitivity -3 dBm typical overload Applications WDM SDH STM-16 LH SONET OC-48 LR Digital recievers.

TA1343N : TV Sound Processor. is a sound processor controlled by I2C bus. It incorporates the following: 2-channel input, 3-channel output signal processing circuit, phase shift circuit for surround, and LPF for woofer channel. ALS (Automatic Level Suppresser) circuit which prevents distort the signal in large signal condition for woofer channel is also incorporated Sound processing.

W5280 : Speech,Melody Processor,Voice Synthesizer. Adpcm Synthesizer w/ 4 Triggers, Stpa, Stpb, Stpc, R0 (3 Seconds @8.0K) (ROMless Controller).

XR17L154 : 3.3V Four-channel Pci-bus Uart. The is a quad PCI Bus Universal Asynchronous Receiver and Transmitter (UART) with same package and pin-out as the Exar XR17C158 octal UART. The device is designed to meet today's 32-bit PCI Bus and high bandwidth requirement in communication systems. The global interrupt source register provides a complete interrupt status indication for all 4 channels.

B828 : ADSL LINE TRANSFORMER Matched to Centillium Padilla CPT73SX01 CPE chipsets Designed to meet EN60950 supplementary insulation requirements for working voltages up to 250Vrms Excellent THD Performance Industry standard surface mount footprint.

STE101P : The STE101P is a high performance Fast Ethernet physical layer interface for 10Base-T and 100Base-TX application. It was designed with advanced CMOS technology to provide MII, RMII and SMII interfaces for easy attachment to 10/100 Media Access Controllers 100Base-TX of IEEE802.3u and 10Base-T of IEEE802.3 The STE101P supports both half-duplex and fullduplex.

0-C     D-L     M-R     S-Z